RSS

The Reel Lawn Mower – An Introduction

Lawn mowers are broken down into 2 basic categories- reel mowers and rotary mowers. The 1st reel lawn mower was invented by an english engineer by the name of Edwin Budding in 1830. The rotary lawn mower was invented in 1933 by a company called Power Specialties of England. In order to figure out which sort of mower is most suitable for you, itis critical to have a look at what they both have to offer . Read on

The Reel Lawn Mower

Reel lawn mowers are made of blades that turn around on a cylinder. As the name implies, the blades are called a reel. Itis the reel that cuts the grass, graszoden in Dutch. Some reel mowers need to be manually pushed by an individual to work while others have an engine.

The reel mower has rotating blades that connect to a stationary bar that lies parallel to the ground below. As the mower is pushed forward, the blades and the bar ( known as a bed knife ) make contact with each other. Itis the bed knife that makes the grass stand upright so that it can be cut by the blades. The reel mower is often called having a shearing action and can be changed to cut grass that is of varying heights.

It is because of the shearing action that reel mowers can cut to a shorter length than can rotary mowers. The cut is also much cleaner. For example, reel lawn mowers are used on golf courses as opposed to rotary mowers for this very reason. The grass clippings from a reel mower have a tendency to be finer than most rotary mowers, with the exception of special mulching rotary lawn mowers.

The bed knife of a reel mower must be adjusted accordingly in order to cut the grass in the right way. The grass will not be cut very well if the bed knife is either too close to the blades or too far away. Changing the bed knife is often a{ very |n extremely | simple task to perform.

The Rotary Lawn Mower

Rotary lawn mowers on the other hand are composed of a flat horizontal blade that turns as agreed by the engine's speed. The engine of a rotary mower is on a housing called a deck. The shaft of the engine goes through the deck and the blade that cuts the grass is meticulously attached with a bolt to the bottom of the shaft. It sounds more involved than it is. The underside of the deck is there to offer protection to the individual using it from being hurt by the blade. The bottom is also there to make sure that the grass is lifted up as it is supposed to be.

Traditional rotary lawn mowers have given way to a selection of rotary mulching lawn mower that's excellent at cutting grass into very fine pieces. A number of these mulching lawn mowers are made with a single blade while others have 2 blades. Most of the more recent rotary mowers have 2 blades.

Rotary lawn mowers work fine on grass that is long but donot tend to cut as cleanly or as uniformly as do their manual counterparts, the alreadymentioned reel mowers. The spinning blade of a rotary mower has the bias to bend the grass as it goes over it meaning that some pieces of grass remain standing while the rest is cut.

If you were thinking about to renew the grass in your garden, then get some ideas from grasmatten.

Tags: , ,

Comments are closed.

© Copyright 2010 MowerDeals.Com